"LOW COST" LOAD LIMITER
MarkE




CHECK FOR LAST UPDATE
on our new website www.sensy.com
 

The accuracy of an electronic limiter at the price of an electromechanical one !!!

The MARKE is a simple electronic limiter with a single set point, for placement on a DIN rail.

As opposed to the classic electronic limiter that usually works with load cells generating a mV/V output, the MARKE input is a 4..20mA signal. Amplification therefore occurs in the load cell.
 

The advantage here is that the distance between the load cell and the limiter is no longer restricted and can easily stretch to 100 meters.

The MARKE enables adjustments to be carried out at a safe place ( and not always at the fixed point as is the case with the electromechanical limiter ) and this also with calibration weights below 110% of the nominal load.

Further advantages over the electromechanical limiter are the hysteresis function, the inbuilt time delay and the input signal filter. The latter two ensure that the MARKE does not interpret dynamic effects as overloads

Very easy to install and adjust.
An ideal appliance for applications where limiters are needed as a matter of course !!!

FULL DATA SHEET

SENSY s.a.
 SENSORS and SYNERGY
 Allée Centrale
B-6040 JUMET
Tel.  : +32 71 25 82 00
Fax : +32 71 37 09 11
 To contact us...